Filling In the Component Balance Output Tab

The Output tab contains the selection of output Attributes for the elements in the model. These Attributes hold the values for the reconciled measurement and tolerance, as well as statistical results, such as Solvability and Imbalance. The selected values and tolerances are the outputs from the Sigmafine Reconciliation engine.

Figure 280: Component Mass Balance Configuration - Output tab

Note: The input values you use for the parameters listed in the following table must be valid ones specified in the Element templates.

Output Tab - Measurements and Flows

Parameter	Default Attribute Name	Unit Class	Description
Reconciled Status	InferredStatus	Dimensionless	Inferred In\Out of service status from the reconciliation.
Reconciled Mass	ReconciledMass	Mass	Reconciled Mass.
Reconciled Tolerance	ReconciledMassTollerance	Mass	Reconciled Tolerance associates with the Reconciled Mass.
Solvability	ReconciledMassSolvability	Dimensionless	Reconciled Mass Solvability Status.
Influence	ReconciledInfluence	Dimensionless	Influence of the reconciled mass measurement on the measurement system.
Reconciled Adjustment	ReconciledMassCorrection	Mass	Adjustment on the reconciled mass.
Test 1	ReconciledMassTest1	Dimensionless	Test of measurement relative to its tolerance.
Test 2	ReconciledMassTest2	Dimensionless	Test of measurement relative to its reconciled tolerance.

Output Tab - Balances

Parameter	Default Attribute Name	Unit Class	Description
Initial Imbalance	ReconciledMassImbalance	Mass	Imbalance of measured\corrected masses around the balance point.
Variance	ReconciledMassVariance	Mass	Variance of measurements around a balance point.
Test 3	ReconciledMassTest3	Dimensionless	Test of balance relative to the allowed tolerances.
Test 4	ReconciledMassTest4	Dimensionless	Test of balance relative to the allowed reconciled tolerances.
Reconciled Residual	ReconciledResidual	Dimensionless	Imbalance of reconciled masses around the balance point.